Design for Manufacturing


最早接触到 Design for Manufacturing 这个概念是在 smic 的研讨会上,最近又在 techonline 上看到 一篇文章 ,这里把其中的部分内容总结一下:

Design for manufacturing or DFM: 考虑–制造、封装、测试(生产链)下的良率

促使DFM的因素:

1.more complex photolithography operations for deep-submicron designs
集成电路设计进入深亚微米下的越趋复杂的光刻操作

2.higher design complexity
设计复杂度的增大

3.shrinking device geometries and more devices per unit area on a chip
器件尺寸的缩小及芯片单位面积器件数量的增加

4.more complex processing operations.
更为复杂的工艺(操作)

design for yield (DFY), which includes DFM and DFT

The three types of chip defects:

1.random defects
其产生机制不特指向某个工艺步骤,其可能导致完全失效或不合性能要求,具体包含:

  • a foreign particle on the wafer that may cause a short between two interconnect lines (晶片上的异种粒子造成互连线间的短路)
  • a short caused by a metal bridge between two lines  (导线间的金属桥联导致的短路)
  • failure of a contact to open  (接触(孔)的开路)
  • a break in an interconnect line  (互连线的断裂)
  • a pinhole in a transistor’s gate oxide  (晶体管栅氧的针孔)

2.systematic defects
设计、工艺、测试、都会在芯片中引入 systematic defects
通常在工艺中减小 systematic defects 的方法(特别是尖端图样 leading-edge geometries  中)是采用 optical pattern correction (OPC) 技术来使芯片上的图样与设计的图样更为接近。但 OPC 需要而外的成本(金钱与时间)

3.parametric defects.
制造工艺和应用环境中实际与平均值之间的变化,例如
工艺误差、温度和工作电压的变化…
模拟 parametric defects 比较复杂,需考虑大量的参数的变化以及敏感性的分析。

模拟/混合信号的芯片对 parametric yield loss 更为敏感。原因在于,模拟电路的设计参数比数字控制、数据通路电路的参数要复杂得多。

parametric defects 在所有工艺考虑
random defects 主要是在 250nm 到130nm
systematic defects 出现在 90nm


版权声明: 本站文章版权所有,转载须以超链接形式标明文章原始出处和版权信息。

Design for Manufacturing》有3个想法

回复 Jason 取消回复

您的电子邮箱地址不会被公开。 必填项已用*标注